top of page
Crank Trigger Kit include
-
Trigger Wheel
-
Distributor Block-Off Plate (Billet Aluminum 6061)
-
Stainless Steel Crank Sensor Mount
-
VR Crank Angle Sensor
-
Hardwares
Machined Factory Pulley
-
Use Dial plate find and Mark the degree as the picture shown.(witch is the CPS position)
-
Require machining pulley to exact dimension shown on figure by Lathe.
Drills & Taps
-
Place Number #1 tooth (the tooth after missing tooth) alingn to the 105° marked on the pulley.
-
Marking the drilling points in the middle of the slots
-
Drills and Taps (3) or (6) M5x0.8mm threads
Installation
-
Install the sensor and check the alignment.
bottom of page